Husqvarna Viking Designer Sapphire 85 User Manual page 14

Embroidery/Darning Foot R
Used for free motion embroidery, free motion quilting, free motion stitching and free
motion darning. When using this foot, select free motion floating in the free motion
options pop-up in sewing mode.
This foot can also be used for hoop embroidery.
Side-Motion Foot S
Used for side-motion/omnimotion stitches.
Sensor One-Step Buttonhole Foot
Plug into the machine then enter the desired buttonhole length to sew sensor one-step
buttonholes. The middle mark measures a ⅝" (15mm) from fabric edge.
Self-Adhesive Glide Plates
If sewing on foam, vinyl, plastic, or leather, the material can stick to the foot and
prevent the sewing machine from feeding properly. When using any of the above
materials, sew on a piece of scrap fabric, to make sure the machine feeds smoothly. If
not, fasten the self-adhesive glide plate to the underside of the presser foot.
Interchangeable Dual Feed
The Interchangeable Dual Feed Foot with changeable presser feet is designed to feed
layers of fabric and/or batting evenly. It is perfect for quilting, sewing velvet, stretch
fabrics, imitation leathers and fabrics that need precise pattern matching. Snap on the
Changeable Straight Stitch Foot when using the straight stitch in the center needle
position with a stitch length up to 6mm. Snap on the Changeable Zigzag Foot when
selecting stitches up to 7mm wide and 6mm long.
14 1 Introduction