HP 4934A Operating And Calibration Manual page 122

HP 4934A TIMS Remote Control Commands, continued
Command
Description
DIALON
Sets DIAL key on.
DIALOFF
Sets DIAL key off.
TERM
Sets 8RDG key off.
BRIDGE
Sets BRDG key on.
THOLDON
Sets the Tx HOLD key on.
THOLDOFF
Sets the Tx HOLD key off.
RHOLDON
Sets the Rx HOLD key on.
RHOLDOFF
Sets the Rx HOLD key off.
LF
Sets MEAS to LEVEL FREQ selection (as with the MEAS key).
NOISE
Sets MEAS to NOISE selection.
NWT
Sets MEAS to NOISE W TONE selection.
STN
Sets MEAS to SIG TO NOISE selection.
IMN
Sets MEAS to IMPULSE NOISE selection.
PAR
Sets MEAS to P/AR selection.
NTG
Sets MEAS to N.T.GND selection,
CMES
Sets FILTER to C-MSG selection (as with the FILTER key).
3K
Sets FILTER to 3 kHz FLAT selection.
15K
Sets FILTER to 15 kHz FLAT selection.
PROG
Sets FILTER to PRGM selection.
50KB
Sets FILTER to 50 kBIT selection,
5M
Sets Impulse Noise PERIOD to 5 MIN (as with PERIOD key).
15M
Sets Impulse Noise PERIOD to 15 MIN selection,
60M
Sets impulse Noise PERIOD to 60 MIN selection.
CONT
Sets Impulse Noise PERIOD to NON-STOP selection.
7-6 Remote Control