Basic Maintenance Schedule - Generac Power Systems MLT3060MV Owner's Manual

Light tower

Hide thumbs Also See for MLT3060MV:

Operating manual (38 pages)

Table Of Contents

Table of Contents

Maintenance

the mast lock bar spring is not broken or missing.

Check the operation of the mast lock bar.

•

Verify the wheel lugs are present and properly

tightened. Refer to

•

Check coolant level in coolant overflow jug daily.

Refer to the engine operator's manual for coolant

recommendations and proper mixture. Normal

operating level is between the 'full' and 'add'

markings on the overflow jug.

•

AFTER ENGINE IS STOPPED AND COMPLETELY

COOL, coolant may be added directly to the coolant

overflow jug.

•

Check the oil level daily. Refer to the engine

operator's manual for the appropriate oil specification.

Verify the oil is correct for special operating conditions

such as a change in season or climate.

•

DO NOT start the unit if the engine oil level is below

the add mark on the dipstick.

•

Normal operating level is in the cross-hatch pattern

between the full and add markings on the dipstick.

Maintenance Activity

Check oil level

Check coolant level

Check fuel level

Check tire pressure

Check all electrical connections

Inspect radiator fins for debris, clean as required

Inspect light tower winch for proper operation

Fuel tank - drain water

Check air cleaner

Belt and belt tension - inspect and adjust

Replace fuel filter

Drain and clean fuel tank

Check glow plugs

Lubricate leveling jacks

Replace engine oil and oil filter

Bolts and nuts on the engine - retighten

Replace heated fuel filter (if equipped)

Inspect engine starting battery

Perform after the initial 50 hours of operation, then on the regularly scheduled interval indicated in the schedule above.

Certain conditions may require the fuel tank to be drained and cleaned more often. When operating in extremely

dusty conditions, clean the fuel tank as often as necessary.

Towing

Safety.

Basic Maintenance Schedule—Mitsubishi Engine

•

Add oil only if the oil level is below the add mark on

the dipstick. DO NOT OVERFILL.

•

Check the fuel level.

•

If the unit is connected to a remote start or transfer

switch, verify the remote switch is off and tagged.

NOTE: If the engine was run out of fuel or the fuel tank

drained, it may be necessary to bleed the fuel lines. Refer

to the engine operator's manual supplied with the unit.