Section 3:Operation; Light Tower Setup - Generac Power Systems MLT3060MV Owner's Manual

Section 3: Operation

Light Tower Setup

J
D
B
DANGER
High Voltage. Verify area above unit is clear
of overhead wires and obstructions. Contact
with high-voltage power lines will result in
death or serious injury.
WARNING
Do not set up the unit if high winds
> 60 mph
are expected. High winds can cause the
unit to tip or fall, causing severe injury
or machine damage.
1. For maximum light coverage, position the unit at
ground level or in a spot higher than the area being
illuminated.
Figure 3-1. Place the unit on firm ground that
2. See
is relatively flat (less than 5° slope), and then block
the wheels to keep it from moving (A).
3. Pull the locking pin on the tongue jack (B) and
rotate the jack 90°. Install the locking pin. Rotate
the jack handle clockwise to raise the trailer tongue
off the towing vehicle.
Owner's Manual for Mobile Light Tower
H
E
G
C D
Figure 3-1. Set-Up Components
(000260a)
(000297)
F
A
4. A grounding stud (C) is located on the frame of the
trailer near the trailer tongue. For grounding
requirements, follow National Electrical Code
(NEC), state, and local regulations.
5. Pull locking pins (D) on outriggers (E) and pull
each outrigger out until the spring loaded locking
pin snaps into place. Pull the locking pin on each
outrigger jack and rotate each jack 90° so the jack
pad is facing down and the spring loaded locking
pin snaps back into place.
6. Pull the locking pin on rear jack (F) and rotate it 90º
until the spring loaded pin snaps into place. Turn
the jack handle clockwise to start leveling the trailer.
7. Adjust all four jacks by rotating handles (G)
clockwise until the jack pads are firmly in contact
with the ground.
8. Before raising the mast, adjust the lamps. The
lamps may be adjusted up, down, left or right by
loosening the wing nuts on trunnion (H) and aiming
the lamps in the desired direction. Tighten the
hardware completely and make sure the lamps are
connected to junction box (J).
DETAIL C
DETAIL D
DETAIL G
004556
DETAIL H
13