Setting The System Format - Sony BRS-200 Quick Reference Manual

Setting the System Format

Setting Up the Output Video Signal to a Monitor
When the monitor is connected via the AUX1 connector
6
Basic Setups
Set the video signal format and the aspect ratio to be supported by the switcher.
1
Display menu page 951 by pressing buttons MENU t 9 t . (dot) t
5 t 1 in order.
SYSTEM FORMAT
SYS MODE HD
2
Set the video signal format, frame frequency, and aspect ratio by
turning the F1, F2, and F3 controls.
FORMAT: Select HD or SD.
FRAME: Select 59.94 or 50.
ASPECT: Select 16:9 or 4:3.
Note
The "FORMAT" and "FRAME" settings should be the same as those on the
connected cameras.
3
Press the F4 control to confirm the settings selected in step 2.
After the "FORMAT" and/or "FRAME" settings are changed, the message
"Reboot system? [PAGE] (yes) or [EXIT] (no)" appears on the display panel.
Press the PAGE button. The switcher will reboot and operate with the changed
settings.
When only the "ASPECT" setting is changed, "Save setup data? [PAGE] (yes)
or [EXIT] (no)" appears. Press the PAGE button. The changed setting will be
saved.
Set the video signal to be output to a monitor to display the images input from
the cameras. This section explains how to set to a 4-picture multi-viewer to
display so that the images from both cameras can be viewed on one monitor.
1
Press to light up the SW mode button.
2
Press to light up the AUX 1 button.
3
Press to light up the MV button.
4
Turn the F1 control to select "4" for "MV TYPE."
SW MODE MV TYPE
SNAP: 4
The 4-picture multi-viewer display is set for the monitor connected via the
AUX1 connector.
FRAME ASPECT
59.94 16:9
XPT HOLD ME AUTO
OFF
APPLY 1/5
951
Exec
30