Basic Setups; Turning On The Power - Sony BRS-200 Quick Reference Manual

Basic Setups

Turning on the Power

4
Basic Setups
This section explains the basic setups required for viewing images shot by the
cameras on the monitor with multi-viewer display, provided that the
factory-preset settings are not changed.
Note
If you have changed the factory-preset settings, use "FACT SET" on menu page
955 to reset the settings to default. For details, refer to the separate Operating
Instructions.
After connection, turn on the power of the system, following the steps below.
1
Set the POWER switch on the front of the Processor Unit to ON (? side).
The POWER indicator lights in green.
2
Set the power switch at the rear of the Control Panel to ON.
The display panel and buttons light up.
3
Turn on the power for the peripheral devices.
Note
When the power of the switcher is turned on, "No Communication." may be
displayed momentarily. The message will disappear after a while.