Removing The Compressor Terminal Box, The Relay & Overload And Run Capacitor - Whirlpool JOB AID GC1SHAXM Installation And Operation Manual

REMOVING THE COMPRESSOR TERMINAL BOX,
THE RELAY & OVERLOAD AND RUN CAPACITOR
WARNING
Electrical Shock Hazard
Disconnect power before servicing.
Replace all parts and panels before
operating.
Failure to do so can result in death or
electrical shock.
1. Unplug refrigerator or disconnect power.
2. Remove the six screws from the unit com-
partment cover and remove the cover.
Unit Compartment Cover Screws (3 of 6)
3. Place a screwdriver blade into the indi-
cated slot of the compressor terminal box
cover, and pry the cover off the box.
Pry Cover Off
Terminal Box
4-11
4. To remove the compressor terminal
box:
a) Use a screwdriver and pry the top of the
terminal box away from the compres-
sor.
Pry Top Of Terminal Box
Away From Compressor
b) Use a screwdriver and unsnap the
locking tab at the lower front of the
compressor, then pull the box away
from the compressor so that you can
access the relay and overload.
Pry Lower Front Of
Terminal Box Away
From The Compressor
Continued on the next page.