Product Information; Declaration Of Conformity; Open Source Software; Product Data For Energy Consumption - Bosch Control 8311 Operating Instructions Manual

Product Information

H Danger to life due to current
▶ Installation and commissioning as well as
maintenance must only be carried out by an
approved and qualified heating contractor.
▶ Electrical work may only be carried out by an
authorised specialist.
H Heating system damage due to frost
When the heating system is not in operation
(e.g. control unit switched off, fault shutdown),
there is a risk of it freezing when there is frost.
▶ When decommissioning or switching off for
extended periods, drain the heating and drinking
water pipes at the lowest point in order to protect
the heating system from freezing and drain at
further drainage points (e.g. upstream of the non-
return valves).
H Inspection and maintenance
Regular inspection and maintenance are prerequisites
for safe and energy efficient operation of the heating
system.
We recommend you enter into a contract for the
annual inspection and demand-dependent
maintenance with an authorised installer.
▶ Have work carried out only by an approved installer.
▶ If any faults are discovered, have them remedied
immediately.
4
2 Product Information
These instructions contain important information for the system user
regarding safe operation of the control unit.
▶ Please observe the operating instructions for the control unit and the
heat source.
Operation of the control unit for the module-specific application is
described below.
Depending on the software version, the display and menu items shown
in the instructions may differ from those in the control unit.
2.1

Declaration of Conformity

The design and operation of this product conform to European Directives
and the supplementary national requirements. Its conformity is
demonstrated by the CE designation.
You can view the Declaration of Conformity on the internet ( back cover).
2.2

Open Source Software

This product contains proprietary software by Bosch (licensed
according to the Bosch standard licensing conditions) and Open Source
Software (licensed according to the Open Source licensing conditions).
The special provisions stated in the license texts apply for LGPL,
reverse engineering is permitted for these components in particular.
You can find Open Source information on the DVD supplied with the
device/product.
2.3

Product data for energy consumption

The specified product data correspond to the requirements of the EU
Regulation No. 811/2013 which supplements ErP Directive 2010/30/
EU. The class of the temperature controller is required to calculate the
central heating energy efficiency of an integrated system and is for this
reason incorporated into the system data sheet.
Function of the CC 8311/CC 8313
CC 8311/CC 8313 and remote control
Room temperature-dependent, modulating
CC 8311/CC 8313
and outside temperature sensor
Weather-compensated, modulating
Weather-compensated, on/off
CC 8311/CC 8313 and outside temperature
sensor and remote control
Weather-compensated with influence of room
temperature, modulating
Weather-compensated with influence of room
temperature, on/off
1) Classification of the user interface according to EU Regulation 811/2013 for the
identification of system packages
2) Contribution to seasonal energy efficiency for central heating in %
Table 2 Product data with regard to energy efficiency of the user
interface
Control 8311/8313 – 6720859790 (2020/02)
1) 1)2)
Class [%]
V 3.0
II 2.0
III 1.5
VI 4.0
VII 3.5