Product Information; Declaration Of Conformity; Open Source Software; Tools, Materials And Miscellaneous Parts - Bosch Control 8310 Installation And Operating Instructions Manual

Product Information

2 Product Information
This installation and maintenance instructions contain important
information for the safe and correct installation, initial commissioning,
and maintenance of this control unit.
Depending on the software version, the display and menu items shown
in the instructions may differ from those in the control unit.
The operating instructions contain information on operation of the
control unit.
▶ Observe operating instructions of the control unit and the heat source.
Software
These instructions describe all the possible functions of the control unit
with software version ≥ SW 1.8.x.
2.1

Declaration of conformity

The design and operating characteristics of this product comply with the
British, European and supplementary national requirements.
The UKCA and CE markings declare that the product
complies with all the applicable British and
European legislation, which is stipulated by
attaching these markings.
The complete text of the Declaration of Conformity is available on the
Internet: worcester-bosch.co.uk.
2.2

Open Source Software

This product contains proprietary software by Bosch (licensed
according to the Bosch standard licensing conditions) and Open Source
Software (licensed according to the Open Source licensing conditions).
The special provisions stated in the license texts apply for LGPL,
reverse engineering is permitted for these components in particular.
You can find Open Source information on the DVD supplied with the
device/product.
2.3

Tools, materials and miscellaneous parts

You will require the following to carry out installation, assembly and
maintenance:
• Electrical engineering tools and measuring devices
The following may also prove useful:
• A PC for commissioning and service
2.4

Scope of delivery

Upon delivery:
▶ Check that the packaging is in perfect condition.
▶ Check the scope of delivery for completeness.
The scope of delivery includes:
• Digital control unit Control 8310
• Fixing materials
• Technical documents
2.5

Accessories

• Function modules
4
2.6

Product description

The extended control unit (without display) provides the possibility to
extend a system with up to 4 function modules.
For operation, the control unit requires a master control unit with
display.
The extension control unit cannot be used as substation of for
controlling a boiler.
2.7

Intended use

The control unit may only be used for extending a master control unit.
▶ Country-specific standards and regulations with regard to
installation and operation must be observed!
2.8

Explanation of the terms used

Heat source
Since various heat sources can be connected to the control unit, the term
"heat source" or "boiler" is subsequently used e.g. for all floor-standing
boilers, other boilers, wall-mounted indoor units, wall-mounted
condensing boilers, heat sources that utilise renewable energies or other
heat sources.
Qualified person
A qualified person is a person who has extensive, specialist, theoretical
and practical knowledge, as well as experience in the specialist area and
is familiar with applicable standards.
Contractor
A contractor is an organisational unit of the industrial sector with
specially trained personnel.
Module
In the following, functional, central, network modules etc. are
designated as module or with the abbreviation of the module
(e.g. FM-AM = AM, FM-MM = MM, FM-ZM = ZM, FM NM = NM).
Control 8310 – 6720856493 (2022/07)