Single Tailwheel Assembly; Dual Tailwheel Assembly - Land Pride RCR2684 Operator's Manual

Section 1: Assembly & Set-up

Single Tailwheel Assembly

IMPORTANT: If chain guards are used, be sure to
install them before installing the tail wheel.
NOTE: Do not tighten hardware until assembly
is complete. Refer to "Torque Values Chart for
Common Bolt Sizes" on page 34.
Refer to Figure 1-12:
1. Slide adjustment plate (#10) onto tailwheel arm (#1)
as shown.
IMPORTANT: The tailwheel arm must be located in
the rear mounting holes of the deck channel when
rear chain guards are included and front mounting
holes when rear chain guards are not included.
2. Attach tailwheel arm (#1) to deck bracket with
5/8"-11 x 3 1/4" GR5 hex head bolt (#2), 5/8" lock
washer (#3), and 5/8" nut (#4).
3. Assemble tailwheel adjusting brackets (#5 & #6) to
deck with four 1/2"-13 x 1 1/2" GR5 carriage bolts
(#7), 1/2" flat washers (#8), and 1/2" lock nuts (#9).
4. Install shim washer (#14) onto yoke spindle (#15)
and insert spindle into tailwheel arm (#1). Slide 2nd
shim washer (#14) onto yoke spindle and secure with
roll pin (#16).
5. Assemble tailwheel mounting bracket (#10), to
adjusting brackets (#5 & #6) with two
1/2" -13 x 1 1/2" GR5 hex head bolts (#11), 1/2" lock
washers (#12), and 1/2" nuts (#13).
6. Refer to "Tailwheel Height Adjustment" on page 16
to adjust tail wheel height.
14384
Single Tailwheel Assembly
Figure 1-12
14
RCR2684
Rotary Cutter 312-785M
Table of Contents

Dual Tailwheel Assembly

IMPORTANT: If chain guards are used, be sure to
install them before installing the tail wheel.
NOTE: Do not tighten hardware until assembly
is complete. Refer to "Torque Values Chart for
Common Bolt Sizes" on page 34.
Refer to Figure 1-13:
IMPORTANT: The tailwheel arms must be located in
the rear mounting holes of the deck channel when
rear chain guards are included and front mounting
holes when rear chain guards are not included.
1. Attach tailwheel arm (#1) to deck bracket (#2) with
5/8" -11 x 3 1/4" hex head bolt (#3), 5/8" lock washer
(#4), and 5/8" nut (#5).
2. Assemble tailwheel adjusting brackets (#6 & #7) to
cutting deck using four 1/2"-13 x 1 1/2" GR5 carriage
bolts (#8), lock nuts (#9), and flat washers (#17).
3. Install shim washer (#10) on spindle (#11). Insert
spindle into tailwheel arm and add 2nd shim (#10) to
yoke spindle. Secure with roll pin (#12).
4. Install two 1/2" -13 x 3 1/2" GR5 hex head bolts (#14),
lock washers (#15), and nuts (#16) in adjusting
brackets (#6 & #7).
5. Repeat steps 1 thru 4 for opposite side.
6. Refer to "Dual Tailwheel" on page 16 to adjust tail
wheel height.
Dual Tailwheel Assembly
Figure 1-13
14385
12/4/18