Location and Function of Parts
Rear Panel
!¡ SET UP switches
!º RS-232C-1 connector
9 AC IN connector
8 REVISION label
7 Breaker
1 RS-232C-2 connector (D-sub 25-pin)
This is for servicing use only.
2 SCSI connectors (Through)
• WD model
(68-pin, SCSI Wide Differential)
Connect this to the host computer with a SCSI-3
compliant P-cable (Differential).
To terminate the connection, connect a terminator
(Differential).
• WS model
(68-pin, SCSI Wide Single-ended)
Connect this to the host computer with a SCSI-3
compliant P-cable (Single-ended).
To terminate the connection, connect a terminator
(Single-ended).
6(E)
1 RS-232C-2 connector
2 SCSI connectors
RS-232C-2
SCSI
TERM POWER
SCSI
SET UP
RS-232C-1
TO TAPE STREAMER
⁄ AC IN
BREAKER
3 TERM (termination) POWER indicator
This lights when power is supplied to the TERM
POWER pin of the SCSI connector from at least one of
the devices connected to the SCSI bus.
If power is supplied from none of the devices
connected to the SCSI bus, this indicator goes off, and
the SCSI bus does not operate.
3 TERM POWER indicator
ID
4 ID switch
5 TO TAPE STREAMER connector
TO GY-2120
6 TO GY-2120 connector
⁄ AC IN
y