Table of Contents
Advertisement
MIC/PGM (program audio) switch
ON: Turns on the headset microphone.
OFF: Turns off the headset microphone.
PGM: Outputs the program audio when the one ear
headset is used. When this position is selected, the
INCOM level control adjusts input level of the
program audio. The level of the PGM1 and PGM2 can
be adjusted by using the VR located on the panel side
of the internal AU board.
Rear panel
a CAMERA connector
a CAMERA connector (triax connector)
Connects to the CA-570/570P/590/590P/905K/F/T
Camera Adaptor attached to the BVP-E10/E10P/E10WS/
E10WSP/E30/E30P/E30WS/E30WSP Color Video
Camera using a triax cable.
Caution
Do not use a defective triaxial cable.
The inner sheath of a triaxial cable is used for power
supply and the outer sheath for safety ground.
6
Function and Location of Parts and Controls
INCOM (intercom) selector
Selects the pathway of intercom signals output/input
through the INCOM/TALLY/PGM connector.
PROD: Producer line.
PRIV: Producer line and engineer line are cut off and
ENG: Engineer line. The settings regarding the output
b AUDIO OUTPUT connectors
c INPUT connectors
d OUTPUT connectors
i WF MODE connector
h MIC REMOTE connector
g INTERCOM/TALLY/PGM connector
For your safety, do not use a triaxial cable whose inner and
outer sheaths are short-circuited. Use of such a cable will
cause electric shock.
b AUDIO OUTPUT connectors (XLR, 3-pin)
Supply audio signals from the video camera.
communication is possible only between the CCU-
590/590P and the camera connected to the rear panel
of the CCU-590/590P.
intercom signals can be performed on the internal AU
board. For details, consult your Sony service
personnel.
e REMOTE connector
f ETHERNET connector
j AC IN connector
Advertisement
Table of Contents
