Sharp KSH-Q11 Service Manual page 7

1. Remove the bottom lid in accordance with "REMOVE OF BOTTOM LID".
2. Fix the thermostat rod, pull the stop ring by using the pliers and straightening
2 claws of thermostat.
3. Remove the thermostat from the thermo plate. Fig 5.
4. Now the thermostat ass'y is free.
1. Remove the bottom lid in accordance with "REMOVE OF BOTTOM LID".
2. Remove the screw and the nut holding the temp. fuse ass'y from the heater terminal and the plug pin.
3. Now the temp. fuse ass'y is free.
1. Remove the bottom lid in accordance with "REMOVE OF BOTTOM LID".
2. Remove the closed terminal holding all lead wires.
3. Disconnect the terminal from the micro SW. and remove the screw holding lead wire of warm heater ass'y
from the heater terminal.
4. Twist 2 claws of reflector and remove the warm heater ass'y.
5. Now the warm heater ass'y is free.
Lead wire of warm heater ass'y
Terminal
Micro SW.
REMOVE OF THERMOSTAT ASSEMBLY
REMOVE OF TEMP. FUSE ASSEMBLY
REMOVE OF WARM HEATER ASSEMBLY
Lead wire yellow
Stop ring
Thermostat rod
Thermo plate
Claw of thermostat
Lead wire blue
7
Fig. 6
Temp. fuse ass'y
Nut
Plug pin
Screw
Heater terminal
Fig. 7
Warm heater ass'y
Lead wire of warm heater ass'y
Claw of reflector
Screw
Heater terminal
Fig. 8