Advertisement
Table of Contents
SHARP SERVICE MANUAL
NAME OF PARTS....................................................................................................
SPECIFICATIONS.....................................................................................................
CAUTION FOR USE.................................................................................................
HOW TO CLEAN THE COOK....................................................................................
CIRCUIT DIAGRAM...................................................................................................
METHOD OF OPERATION........................................................................................
ADJUSTMENT OF SWITCH LEVER AND CONTACTS.................................................
INSPECTION AFTER REPAIRING..............................................................................
TESTING OPERATING CONDITION............................................................................
PROBLEMS AND SOLUTIONS..................................................................................
AUTOMATIC RICE COOKER
MODELS
In the interests of user-safety (Required by safety
regulation in some countries) the set should be
restore to its original condition and only parts identical
to those specified should be used.
TABLE OF CONTENTS
SHARP CORPORATION
KSH-106 / 111
KSH-115 / 118
KSH-122 / 128
Page
2
2
3
3
4 - 5
5 - 6
6 - 7
7
8
9
Advertisement
Table of Contents
Related Manuals for Sharp KSH-106
Summary of Contents for Sharp KSH-106
-
Page 1: Table Of Contents
SHARP SERVICE MANUAL AUTOMATIC RICE COOKER MODELS KSH-106 / 111 KSH-115 / 118 KSH-122 / 128 In the interests of user-safety (Required by safety regulation in some countries) the set should be restore to its original condition and only parts identical to those specified should be used. -
Page 2: Name Of Parts
Upper Lid “WARM” Indicator Lamp “COOK” Indicator Lamp Inner Pot Handle Outer Pot Panel Power Cord Assembly Switch Ass’y (Model KSH-106 cord is fixed with the pot) SPECIFICATIONS KSH-106 KSH-111 KSH-115 KSH-118 KSH-122 KSH-128 Model Voltage (V) Rated frequency (Hz) -
Page 3: Caution For Use
CAUTIONS FOR USE 1. Keep clean the brim and bottom of inner pot, heater plate at all times to avoid sticking cooked rice, uncooked rice grains, dust and dirt. Cooking performance may be made worse by such sticking rice grain and the like. -
Page 4: Circuit Diagram
CIRCUIT DIAGRAM Model : KSH-106 Model : KSH-111 - KSH-128... -
Page 5: Method Of Operation
SCHEMATIC DIAGRAM METHOD OF OPERATION Different degree of temperature at various parts of the cooker during its operation. HEATER PLATE HEATING PLATE INNER POT 100 C THERMOSTAT RICE TEMPERATURE THERMOSTAT CUTS OFF TIME 30 MINUTES After being switch “ON” the operation will be started by generating heat from the heater plate and spread through the bottom of inner pot. -
Page 6: Adjustment Of Switch Lever And Contacts
To repair rice cooker, the following parts should be carefully checked and / or repaired in the proper manners. 1. Inner Pot Outer Side : It must be cleaned without any contaminants and particles at the bottom for it can be firmly contacted the heater plate evenly. -
Page 7: Inspection After Repairing
2. As soon as inner pot is lifted up from outer pot, switch lever must be spring up and micro switch is pressed completely. This rice cooker is so designed that the cooking switch will not be put in “COOK” position whenever the inner pot is taken off or not set into the cooker before use. -
Page 8: Testing Operating Condition
TESTING OPERATING CONDITION (1) Simplified Testing Method 1. Firmly put inner pot into the cooker, and also close the lid. 2. Plug the power cord. 3. Push switch cook to check the operation of thermostat. It will cut off approximately in 3-5 minutes, which is the standard timing. -
Page 9: Problems And Solutions
PROBLEMS AND SOLUTIONS Problems Possible Causes Solution Check . Incompletely cooked 1. Inner pot improperly 1. Adjust or replace. Boil about 800 cc. of rice. with heater plate. water. Check the state 2. Failure in setting inner pot. 2. Adjust. of bubbles at the bottom 3.