Front Panel Header - ECS 761GXM-M2 Manual

12
SPK1: Internal speaker
Pin
1
2
3
4

Front Panel Header

The front panel header (PANEL1) provides a standard set of switch and LED headers
commonly found on ATX or Micro ATX cases. Refer to the table below for informa-
tion:
Pin Signal Name
1 HD_LED_P
3 HD_LED_N
5 RST _SW_N
7 RST_SW_P
9 RSVD
* MSG LED (dual color or single color)
Hard Drive Activity LED
Connecting pins 1 and 3 to a front panel mounted LED provides visual indication
that data is being read from or written to the hard drive. For the LED to function
properly, an IDE drive should be connected to the onboard IDE interface. The LED
will also show activity for devices connected to the SCSI (hard drive activity LED)
connector.
Power/Sleep/Message waiting LED
Connecting pins 2 and 4 to a single or dual-color, front panel mounted LED provides
power on/off, sleep, and message waiting indication.
Reset Switch
Supporting the reset function requires connecting pin 5 and 7 to a momentary-
contact switch that is normally open. When the switch is closed, the board resets and
runs POST.
Signal Name
+5V
NC
GND
SPKR
Pin Signal Name
Function
Hard disk LED(+) 2
Hard disk LED(-) 4
Reset Switch(-) 6
Reset Switch(+) 8
Reserved 10 Key
Installing the Motherboard
Function
FP PWR/SLP *MSG LED(+)
FP PWR/SLP *MSG LED(-)
PWR_SW_P Power Switch(+)
PWR_SW_N Power Switch(-)
No pin