Agri-Fab 45-0529 Manual page 7

STEP 12: (SEE FIGURE 12)
1. Attach the latch stand and the wheel support braces
to the poly tray using four 1/4" x 1" hex bolts (D),
5/16" washers (W), and 1/4" nylock nuts (I).
D
W
I
FIGURE 12
STEP 13: (SEE FIGURE 13)
1. Raise the tongue to the latch stand and engage the
latch to ensure proper alignment. Adjust as needed.
2. Tighten all fasteners.
FIGURE 13
STEP 14: (SEE FIGURE 14)
1. With the valve stem facing out, place the wheel onto
the axle and secure with a 1" washer (M) and a 3/16"
x 2" cotter pin (T). Spread the ends of the cotter pin.
Repeat for the other side.
2. Pump wheel bearing type grease into the grease
fittings on the wheels until a small amount is forced
out the ends of the wheel hubs.
T
FIGURE 14
7
VALVE STEM
M
T