Milwaukee HDE 13 RQD Manual page 4

Heavy-Duty, Reversing 13 mm
D-Handle Hole-Shooters 1107-50, 3107-4
For additional safety instructions, read Safety Instruction Book No. 58-13-0000.
No Load
Catalog
Number
Speed (RPM)
1107-50
0 - 500
Lo
3107-4
0 - 335
- 0 - 750
Sound and Vibration Information 1107-50 & 3107-4
• Typically the A-weighted sound pressure level of the tool is less than 82 dB (A). The noise
level when working can exceed 95 dB (A). Wear ear protection!
• The typical weighted acceleration is 2,5 m/s
CE Declaration of Conformity
We declare under our sole responsibility that this product is in conformity with the following
standards or standardized documents. EN 55 014, EN 50 144, EN 60 555, EN 55 104 in
accordance with the regulations 73/23/EEC, 89/392/EEC, 89/336/EEC, and 93/68/EEC.
1 - Handle
A
2 - Trigger
3 - Drill Collar
4 - Collar
5 - Chuck
6 - Side Handle
7 - Forward/Reverse Switch
Assembly
Removing and Replacing
B
®
Quik-Lok
MILWAUKEE'S exclusive Quik-Lok
vide instant field replacement or substitution.
1. To remove the Quik-Lok
cord nut 1/4 turn to the left and pull it out.
2. To replace the Quik-Lok
the connector keyways and push the
connector in as far as it will go. Turn the
cord nut 1/4 turn to the right to lock.
Inserting Drill Bits
1. To insert bits, open the chuck jaws wide
enough to allow the bit to strike the
bottom of the chuck. Be sure that the
English
Flat
Boring Hole
Bit Saw
38 mm 125 mm
High
- 38 mm 150 mm
38 mm 114 mm
Cords
®
Cords pro-
® Cord, turn the
®
Cord, align
Wood
Ship
Auger Auger Selfeed
Bit Bit Bit
38 mm 38 mm 92 mm
38 mm 38 mm 117 mm
38 mm 38 mm 65 mm
2
.
shank of the bit and the chuck jaws are
clean. Dirt particles may cause the bit
to line up improperly.
2. Center bit in chuck jaws and lift approxi-
mately 1,5 mm off bottom. Tighten the
jaws by hand to align the bit before
tightening with the chuck key.
Never use a wrench or means other
than a chuck key to tighten or loosen the
chuck. Do not use bits which are larger
than the rated capacity of the drill or
gear damage, motor overload or loss of
control may result. For maximum drill-
ing performance, be sure that the bits
are properly seated.
Trigger Speed Control Switch
MILWAUKEE Drills listed above are equipped
with a trigger speed control switch. It may be
operated at any speed from 0 RPM to full
speed. To vary the speed, grasp handles
firmly and pull the trigger to desired speed.
The further the trigger is pulled, the greater
the speed. To stop the tool, release the
trigger and allow the tool to come to a com-
plete stop.
2
Steel Masonry
Twist Hole Carbide-Tip
Drill Saw
13 mm 95 mm 13 mm
13 mm 127mm 13 mm
13 mm 89 mm 13 mm
1107-50 / 3107-4
Bit