Whirlpool FES310Y Use And Care Manual page 23

4. Lift out the reflector bowl. See "Cleaning
chart" on page 25 for cleaning instructions.
Replacing
1. Make sure all surface units are off and cool
before replacing surface units and reflector
bowls.
2. Line up openings in the reflector bowl with the
surface unit receptacle and the element hold-
down clip.
3. Hold the surface unit as level as possible with
the terminal just started into the receptacle.
Push the surface unit terminal into the
receptacle.
4. When terminal is pushed into the receptacle
as far as it will go, push down the edge of the
surface unit opposite the receptacle. The
element hold-down clip will keep the surface
unit from moving around.
NOTE: Reflector bowls reflect heat back to the
utensils on the surface units. They also help
catch spills. When they are kept clean, they
reflect heat better and look new longer.
If a reflector bowl gets discolored, some of your
utensils may not be flat enough, or some may be
too large for the surface unit. In either case,
some of the heat that's meant to go into or
around a utensil goes down and heats the
reflector bowl. This extra heat can discolor it.
23