Installation Procedure; Apply Foam Tape; Install Backwall Trim - Bosch OVEN Installation Instructions Manual

Ventilation Recommendations

Installation Procedure

Apply Foam Tape

Install Backwall Trim

1. Adjust height of range and level by rotating the adjustable leg supports on the
bottom of the range, using 1-1/4" wrench.
2. Measure to locate bracket position as shown in See Figure 5: Anti-Tip
Bracket.
3. Secure bracket with 2 screws adequate for mounting surface (i.e., for wood
floor use wood screws, for concrete floor use concrete anchors and screws).
We strongly recommend the installation of a ventilation hood above this appli-
ance. For most kitchens a certified hood rating of not less than 300 CFM is recom-
mended. The range hood must be installed according to instructions furnished
with the hood.
Apply foam tape to underside of cooktop trim in one continuous piece.
Note: DO NOT use caulk or glue/adhesive of any kind.
Note: This step is only required if the countertop does not connect behind the
range (i.e.; when replacing a free-standing range). See "Cabinet Requirements"
on page 6 for more information
rear wall
cabinet wall
flush against
cabinet wall
1 9/16" (39.7 mm)
from rear wall to center of screw hole
floor
anti-tippin g
device
Figure 5: Anti-Tip Bracket
English 7