Bosch OVEN Installation Instructions Manual page 16

Three Wire Flexible Conduit Connec-
tion
English 14
Note: DO NOT plug in range at this time.
The Four Wire Connection is preferred, but where local codes and ordinances
permit grounding through neutral and/or conversion to four wire is impractical, unit
may be connected to the power supply via a three wire connection.
1. Disconnect electrical power at the breaker box.
2. Remove the terminal block cover to expose the terminal block.
3. Remove the top nut, star washer, and round washer from each post.
Note: DO NOT remove last round washer, last nut or internal wire leads.
4. Place one terminal lug (packaged with this manual) on each post. Replace the
star washer and round washer and secure with 20 inch pounds of torque.
5. Strip 3/8 (9.53 mm) inches of insulation from the end of each wire.
6. Insert stripped end of white wire into the center lug on top of the ground strap.
Secure the clamping screw.
.
lug
wire
7. Insert stripped end of red wire into the left lug. Secure clamping screw.
8. Insert stripped end of black wire into the right lug. Secure clamping screw.
Terminal Block
Figure 19:
Wire Stripping
Figure 20:
clamping screw
Attaching Wire to Lug
Figure 21:
3/8 "