Ignition And Starter Lock; Main Fuse - Husqvarna Rider 111 B Workshop Manual

Ignition and Starter Lock

1 Release the contact box from the ignition lock by
pulling it straight down.
2 Remove the ignition key and the rubber seal.
3 Remove the nut and the ignition lock.
Assemble the parts in the reverse order. Make
sure the connector ends up in the proper position
(click-lock).

Main fuse

The main fuse is placed in a detachable holder
behind the battery under the protective cover.
Type: Flat pin, 15 A.
Do not use any other type of fuse when replacing.
A blown fuse is indicated by a burnt connector.
Pull the fuse from the holder when replacing.
The fuse is there to protect the electrical system.
If it blows again shortly after replacement, it is due
to a short circuit, which must be fi xed before the
machine can be put into operation again.
Electrical system
45
English –