Ignition and Starter Lock
1.
Loosen the right-hand wing cover.
2.
Remove the inner protecting plate on the
gear lever carrier.
3.
Release the connector from the ignition
lock by pulling it straight down.
4.
Remove the ignition key and the rubber
seal.
5.
Remove the nut and the ignition lock.
Assemble the parts in the reverse order.
Make sure the connector ends up in the
proper position (click-lock).
Main fuses
The main fuse is placed in a detachable
holder under the battery case's cover, in front
of the battery.
Type: Flat pin, 15 A.
Do not use any other type of fuse when
replacing.
A blown fuse is indicated by a burnt connec-
tor. Pull the fuse from the holder when replac-
ing.
The fuse is there to protect the electrical sys-
tem. If it blows again shortly after replace-
ment, it is due to a short circuit, which must
be fixed before the machine can be put into
operation again.
ELECTRICAL SYSTEM
Ignition and Starter Lock
Main fuse
8042-116
8009-370
117
English-