Panasonic EP3513CU Operating Instructions Manual page 32

3. Adjust massage position and strength.
(These adjustments cannot be made with the controller cover closed.)
Adjusting Massage Position
position
Press
Adjusting Massage Strength
intensity
Press .
Adjusting Massage Speed
speed
Press .
Adjusting Lateral Movement
lateral
Press
Combining with the Back Vibration
vibration
Press .
(Press again to turn off.)
4. When the massage is finished the unit will automatically shut off.
(The massage will finish approximately 15 minutes after it starts.)
• The massage heads will retract and then stop.
30
• The approximate position of the massage will be shown on the Massage Area Display.
• If you hold the up or down button down the massage heads will continue to move until you release
the button.
.
• In some places the strength of the massage will be automatically reduced. (See Page 33)
• In some cases the massage position will not immediately change even though the Roller Position
button is pressed.
• The strength of the massage is shown on the Upper Body Massage Action Display in five stages.
• In some cases the degree to which the strength of the massage can be adjusted will depend on
the area being massaged. (See Page 31)
• In some cases the massage strength will not immediately change even though the Massage
Strength button is pressed.
• The strength of the back vibration function is not adjustable.
• The speed of the massage is shown on the Upper Body Massage Display in five stages.
• The speed of the back vibration function is not adjustable.
• Press this button to increase the width of the massage in the location the massage
heads were in when you pressed the button.
• will be shown on the display.
• In some places the strength of the massage will be automatically reduced.
.
(See Page 33)
• Back vibration cannot be combined.
• Press the button again to revert to normal massage action.
The display will indicate whether the back
vibration function is turned on or off.
(Lit areas indicate active functions. Unlit
areas indicate inactive functions.)
Back
Vibration