Advertisement
1. Add an entry with the following values for fields on Page 1, as displayed in Figure 5
below:
• Service Type: "AESVCS"
• Enabled:
• Local Node:
• Local Port
change ip-services
Service
Enabled
Type
CDR1
CDR2
AESVCS
y
2. Go to Page 4 of the IP Services form, and enter the following values as displayed in
Figure 6:
• AE Services Server: Name obtained from the Avaya AES server, in this case
"AES-Test".
• Password:
• Enabled:
Note that the name and password entered for the AE Services Server and Password
fields must match the name and password on the Avaya AES server. The administered
name for the Avaya AES server is created as part of the Avaya AES installation, and can
be obtained from the Avaya AES server by typing "uname –n" at the Linux command
prompt. The same password entered in Figure 6 below will need to be set on the Avaya
AES server using Administration
Password as displayed in Figure 12.
change ip-services
Server ID
AE Services
1:
AES-Test
2:
3.3. Administer CTI Link with TSAPI Service
Add a CTI link and set the values as displayed in Figure 7 below using the "add cti-link n"
command, where "n" is an available CTI link number.
1. Enter an available extension number in the Extension field. Note that the CTI link
number and extension number may vary. Enter "ADJ-IP" in the Type field, and a
SVS; Reviewed:
SPOC 6/18/2008
"y"
Node name for the Clan-1 assigned in Figure 2.
Retain the default of "8765".
IP SERVICES
Local
Node
Clan-1
Clan-1
Clan-1
Figure 5: IP Services Page 1
Same password to be administered on the Avaya AES server.
"y"
AE Services Administration
Password
Server
***
Figure 6: IP Services Page 3
Solution & Interoperability Test Lab Application Notes
©2008 Avaya Inc. All Rights Reserved.
Local
Remote
Port
Node
0
TestSite
0
CDR-2nd
8765
Switch Connections
Enabled
y
Page
1 of
3
Remote
Port
9002
9004
Edit Connection
Page
3 of
3
Status
AES41-Taske
Set
6 of 39
Advertisement
