Grizzly G0636X Owner's Manual page 54

9. Figure 66 shows positions of wheels when
coplanar. When wheels are coplanar, re-
install table, table insert and pin, re-adjust
guide blocks and rear support bearings, and
close wheel covers.
10. Finally, check table and fence alignment (see
Pages 28 & 29).
Coplanar
Coplanarity
Gauge
Contacts Top
And Bottom of
Both Wheels
-52-
Note: The blade may track slightly off-center
when the wheels are coplanar. This is natural
because the blade will be balanced on the crown
of the tire, rather than just in the center of the tire.
This will be more noticeable with larger blades.
Parallel, Not
Coplanar
Shim Upper
Wheel Out
Figure 66. Coplanarity diagram.
Not Parallel
Not Coplanar Tracking Knob
Adjust
Lower
Hub
Model G0636X (Mfd. Since 09/18)
Adjust