General Information
General Information
1.1
Introduction
With SENTRON SOFTWARE ATC remote control software, you can connect one or several
ATC transfer switches to a PC via a RS 232 serial port or a RS 485 serial bus.
It can be used for commissioning of the controller, for troubleshooting in case of problems and
also for continuous supervision.
The software provides the following functions:
•
Graphic display of all the measurements returned by the device
•
Access to the Setup menus
•
Access to ATC Real time clock
•
Access to ATC statistic data
•
Possibility of set-up parameter save/load/printout
•
Display of virtual front panel of the controller with the possibility of activating the keys
•
Switching between operation modes
•
ATC device keypad lock
•
Display of the Event log, showing the most recent 100 events with date and time
1.2
Minimum Resources of the PC
•
Windows® 95/98/2000/XP operating system
•
Graphic card with 1024x768 or higher resolution
•
A free standard RS 232 serial interface (COM:)
•
64 Mb of RAM
•
Pentium® class or higher processor
•
CD-ROM drive for installation
ATC5300
Remote Control Software Manual, Edition 03/2011, A5E02469028-02
1
3