Table of Contents
Advertisement
3.7
Offline Programming
When the user is working without an ATC device connected to the PC (Offline mode), then all
the transfers are from / to the hard disk. In this mode it is possible to:
•
Load an existing file from disk, show its content on the setup table window (Parameters-
Load file). From the setup table window is then possible to edit parameters and save them
back to disk (button Save) or print them (button Print).
•
Create a new parameter file with the factory default settings (Parameters-New default file).
In this case the user will be prompted to specify the device model and the software revision
level of the destination device (shown on the device display at power-up). The default
revision is the most recent.
•
Re-open the setup table to edit parameters (Parameters-Edit setup parameters). If the user
tries to edit parameters before having loaded a file, the system will act like when creating
a new file.
3.8
Parameters Files
The following are saved in each .PAR file:
•
Type and internal release of the ATC device
•
Setup parameters of all menus
The online file transfer to an ATC can be done only if the file to be uploaded was created for
the same ATC model and has a compatible software revision, otherwise the software will give
an alarm indication.
ATC5300
Remote Control Software Manual, Edition 03/2011, A5E02469028-02
User Interface
3.7 Offline Programming
13
Advertisement
Table of Contents
