Fan - HP EliteBook 835 G7 Maintenance And Service Manual

3. Use a tool to release the module (3), and then remove the module from the computer (4). The module is
secured with adhesive.
Reverse this procedure to install the NFC module.

Fan

To remove the fan, use this procedure and illustration.
Table 6-10 Fan description and part number
Description
Fan assembly
Before removing the fan, follow these steps:
1. Prepare the computer for disassembly
2. Remove the bottom cover
3. Disconnect the battery cable from the system board (see
Remove the fan assembly:
1. Disconnect the fan cable from the system board (1).
2. Remove the cables from the clips on the side of the fan (2).
(Preparation for disassembly on page
(Bottom cover on page 33).
33).
Battery on page 43).
Component replacement procedures
Spare part number
M07102-001
53