Cylinder And Piston - Husqvarna 131RB Workshop Manual

3. Put the input shaft assembly (O) into the housing
with a pair of pliers or a sleeve.
4. Attach the snap ring (L) for the bearing on the output
shaft. Attach the bushing (K) on the output shaft.
Attach the grease plug (N). Attach the snap ring (M)
for the bearings on the input shaft. Fill the gear with
grease.
N
M
627 - 002 - 23.04.2018
K
L
5. Attach the gear housing (J) on the shaft and tighten
the screw (I). Attach the bracket (H) and tighten the
screw (G). Attach the bracket (F) and tighten the
screw (E). Tighten the screw (D). Attach the
protective plate (C). Remove the rod from the hole
(B) to unlock the axle. Attach the support flange (Y).
Attach the trimmer head (A).
E
F
H
G

8.13 Cylinder and piston

8.13.1 To get access to the cylinder and piston
1. Remove the shaft.
2. Remove the spark plug cover and the spark plug.
3. Remove the cylinder cover.
4. Remove the starter.
5. Remove the muffler and heat shield.
6. Remove the air filter cover, the air filter and the air
filter holder.
7. Remove the carburetor, the distance piece and the
heat shield.
D
J
C
I
Y
B
A
Repair instructions - 51