Husqvarna 131RB Workshop Manual page 25

6. Remove the screw (M) and remove the pulley (N).
Remove the torsion spring (O). Remove the starter
pulley (P) to access the recoil spring (Q). Carefully
remove the recoil spring from the starter housing
(R).
M
N
O
P
WARNING: Be very careful when you
remove the starter pulley. The recoil spring
can eject and cause injury to you.
627 - 002 - 23.04.2018
8.3.2 To disassemble the starter on 967 84 32-xx
1. Remove the screw (A), the spark plug cap (B), the
Q
R
2. Remove the screws (F) and the cylinder cover.
3. Pull out the starter rope approximately 30 cm. Slow
WARNING: Use protective glasses to prevent
injury to the eyes if the recoil spring ejects.
spark plug cable (C) and the spark plug. Remove
the screw (D) from the cylinder cover (E).
A
E
Remove the screws (G and H). Remove the starter
(J), the bracket (I), the gasket (K) and the nuts (L).
K
L
G
the starter pulley with your thumb. Put the starter
rope in the groove in the starter pulley. Let the
starter pulley rotate rearward until the spring tension
stops.
B
D
C
J
F
H
I
Repair instructions - 25