Husqvarna 131RB Workshop Manual page 27

3. Put the pulley on the starter pulley and attach the
screw.
4. Pull the starter rope through the starter rope handle.
5. Make a small knot on the starter rope and pull the
knot into the handle.
6. Tighten the recoil spring. Pull out the starter rope
fully and slow the starter pulley with your thumb. Lift
the starter rope up out of the groove on the starter
pulley. Then turn the starter pulley counterclockwise
4 revolutions. Pull out the starter rope fully and turn
the starter pulley a minimum of a half revolution
more.
627 - 002 - 23.04.2018
7. Attach the gasket (J) and the starter assembly (I).
I J
8. Put the engine on the support plate on the harness
frame. Attach the screws (H) and the screws (G).
Attach the cylinder cover and the screws (F).
F
G
9. Attach the screw (D) to the cylinder cover (E). Attach
the spark plug cable (C). Attach the spark plug cap
(B) and the screw (A). Tighten all screws to the
correct torque. Refer to
967 84 33-xx on page 14
A
E
8.3.6 To assemble the starter on 967 84 32-xx
1. Put the starter pulley down into the starter housing.
2. Put the torsion spring in the starter pulley.
H
Servicing data for the model
B
D
C
Repair instructions - 27