Husqvarna 131RB Workshop Manual page 35

5. Remove the screw (I) and connection plate (J) that
are attached below the stop switch (H).
6. Remove the stop switch (H). Pull out the cable
retainer (K). If it is necessary, remove the black
cable (G) and the red cable (F).
G
627 - 002 - 23.04.2018
H
I
J
H
K
F
8.5.2 To assemble the handle
1. Assemble the black cable (G) and red cable (F) in
the cable retainer (K). Install the cable retainer on
the left handle half. Assemble the stop switch (H) on
the throttle.
G
2. Attach the connection plate (J) and the screw (I)
below the stop switch (H). Use the correct torque,
Servicing data for the model 967 84 33-xx on
see
page 14 .
3. Attach the throttle wire (E) in the throttle trigger (A).
Put the spring (B) into the hole (L) in the throttle
trigger.
E
H
K
F
H
I
J
L
A
B
Repair instructions - 35