5.6.2 To disconnect and connect the motor cables
CAUTION: The connectors and the terminals
can become damaged if you use pliers to
disconnect and connect the cables.
1. Remove the 4 screws and the top gear package
cover.
2. Put a flat screwdriver below the connector.
1235 - 001 -
3. Push up the connectors.
4. Connect the motor cables in the opposite sequence.
5.7 Air conductor
5.7.1 To remove the air conductor
1. Remove the motor cables. Refer to
and connect the motor cables on page 17 .
2. Remove the screw and the air conductor.
To disconnect
Repair instructions - 17