8. Put the input shaft in position with a pair of pliers.
Make sure that the bearing touches the bottom.
9. Put the snap ring (D) on the output shaft.
10. Attach the snap ring (B) on the input shaft.
64 - Repair instructions
11. Put grease into the gear through the grease filler cap
(C) until it comes out through the valve (D).
D
12. Assemble the cutting attachment and spray guards
in the opposite sequence to how they were
disassembled.
D
7.15.3 To disassemble the bevel gear (553RBX)
1. Loosen the screw (A) and remove the splash guard.
2. Remove the screw (B) and remove the plate (C).
3. Loosen the screws (D) and pull the gearbox from the
shaft.
B
C
A
D
B
C
1239 - 001 -