5. Remove the snap ring on the output shaft.
6. Remove the snap ring (B) on the input shaft.
D
7. Remove the grease filter plug (C).
8. Remove the grease filter plug (D).
9. Use a hot air gun to increase the temperature of the
full bevel gear to approximately 110°C.
62 - Repair instructions
10. Tap the bevel gear against a wooden block to
11. Lift the output shaft to remove it.
12. Use a hot air gun to increase the temperature of the
B
13. Disassemble the ball bearing and the gear wheel
C
14. Disassemble the snap ring and remove the ball
disassemble the input shaft.
gear housing to approximately 140°C. Disassemble
the small ball bearing for the output shaft.
from the shaft.
bearing from the shaft.
1239 - 001 -