Canceling A Cycle; Changing A Cycle Or Setting - Whirlpool GU1200XT Technical Education

NOTE: The Soil Sensor monitors water pres-
sure at the output of the drain pump. Cycle time
and/or water usage can vary from the numbers
above as the sensor adjusts the cycle for the best
wash performance. Water pressure varies de-
pending on the soil concentration in the accumu-
lator.
One or all of the following may be used to achieve
the desired washing performance of a selected
wash cycle.
Automatic Purge Filtration
The Automatic Purge Filtration (APF) feature may
also be invoked if the soil sensor detects exces-
sive soils. This can occur during selected wash
or rinse cycles. APF mode provides one or more
purges of excess soils trapped in the soil accu-
mulator at specified intervals in the cycle.
The APF operates for a total of 10 seconds while
the wash motor is operating in a wash or rinse
mode. The accumulator screen will be cleaned
from jets on the underside of the lower spray arm.
During the first five seconds, the drain motor turns
on and the fill valve is activated. This purges the
soiled water from the accumulator and begins to
add fresh water. For the remaining five seconds,
the drain pump is turned off, but the fill valve re-
mains activated to bring wash water up to proper
level.

Canceling a Cycle

Anytime during a cycle, press
The dishwasher starts a two minute drain (if
needed.) Let the dishwasher drain completely.
The light turns off after two minutes.
To Stop the Drain
Press CANCEL/DRAIN a second time to stop the
drain immediately. Always drain the dishwasher
before starting a new cycle.
To Clear the Indicators
Press CANCEL/DRAIN before starting the dish-
washer to clear all options and cycles.

Changing a Cycle or Setting

During the first minute of a cycle:
1. Press a new cycle and/or options.
2. Check the detergent dispensers. They
must be filled properly for the new cycle.
After the first minute of a cycle:
1. Press:
CANCEL/DRAIN glows. The dishwasher starts
a two minute drain (if needed.) Let the dishwasher
drain completely.
2. Check the detergent dispensers. They
must be filled properly for the new cycle.
3. Close the door.
4. Press a new cycle and/or options.
5. Press Start.
4