TEFAL EXPRESS COMPACT ANTI-CALC Instructions Manual page 10

PROBLEMS
Water streaks appear on
the linen.
White streaks come
through the holes in the
soleplate.
Brown streaks come
through the holes in the
soleplate and stain the
linen.
The soleplate is dirty or
brown and may stain the
linen.
There is no steam or
there is little steam.
Steam escapes from the
rinse
plug.
The red "water tank
empty" light is on.
Steam or water escapes
under the appliance.
The "anti calc" indicator
is lit.
Environment protection first !
Your appliance contains valuable materials which can be recovered or recycled.
Leave it at a civic waste disposal centre.
If you have any problems or queries please call our Customer Relations team first for expert
help and advice: 0845 602 1454 - UK / (01) 677 4003 - Ireland
CAUSES
Your ironing board is saturated with water
because it is not suitable for use with a
steam generator
Your boiler has a build-up of scale because
it has not been rinsed out regularly.
You are using chemical descaling agents or
additives in the water for ironing.
You are ironing at too high a temperature. See our recommendations regarding tempera-
Your linen is not rinsed sufficiently or you have
ironed a new garment before washing it.
You are using starch.
The water tank is empty (red light on).
The soleplate temperature is set to the
maximum.
The rinse plug has not been tightened cor-
rectly.
The rinse plug seal is damaged.
The generator is faulty.
The water tank is empty.
The generator is faulty.
You have not pressed the "Restart" button. Press the "Restart" button on the control
or consult our website - www.tefal.co.uk
SOLUTIONS
Check that your ironing board is suitable.
Rinse out the boiler.
Never add this type of product in the water
tank or in the boiler (see § "for what water
may be used"). Contact an Approved Service
Centre.
ture control setting.
Ensure linen is rinsed thoroughly to remove
any soap deposits or chemicals on new gar-
ments which may be sucked up by the iron.
Always spray starch on the reverse side of the
fabric to be ironed.
Fill the tank and press the "Restart" button
until the indicator goes out.
The generator is working but steam is very hot
and dry As a consequence, it is less visible.
Tighten the rinse plug correctly.
Contact an Approved Service Centre to order a
new rinse plug seal.
Stop using the generator and contact an Ap-
provedService Centre.
Press the Restart button on the control panel
until the indicator goes out.
Stop using the generator and contact an Ap-
proved Service Centre.
panel.
GB
D
F
NL
E
P
I
DK
N
S
FIN
TR
GR
PL
CZ
SK
H
SLO
RU
UA
HR
RO
ET
LT
LV
8