Slant/Fin EUTECTIC EC-10 Series Assembly Instructions Manual page 4

4
Reverse the direction of opening of the burner door if necessary
(opening at left).
When the burner leaves the factory, the burner
door opens towards the right. Perform operations
4.1, 4.2 and 4.3 below to open the burner door
towards the left (if absolutely necessary).
4.1
Loosen the 2 top and bottom nuts.
Remove the lower and upper hinges.
4.3
- Reinstall the hinge pins
using the nuts located on the burner door hinge pins, on
the left side, as shown on the adjacent figure.
- Tighten the 2 nuts .
2
1
13
1
2
8575N018
on the left side, fixing them
4.2
- Remove the cast iron hinge pin
fixed by the 2 screws . Put the two screws
on the right-hand side
- Reinstall the cast iron hinge pin
on the left side using the 2 screws
2
6
6
2
4
3
4
3
5
8575N019
for the burner door
back
for the burner door
.
8575N020