Set Up And Charging - Morphy Richards Supervac deluxe Instruction Book

VC734050MUK Rev 3.qxp_Instruction Book 06/03/2018 16:04 Page 4
Multiple functionality
vacuum
cleaning
in upright
mode
Your vacuum cleaner can easily be configured into several different cleaning modes:
• Two configurations as a vacuum cleaner for floors and carpets.
• Handheld vacuum cleaner which can be carried with you whilst cleaning.
• Extended reach vacuum cleaner for cleaning hard to reach places such as high coving etc.

Set up and charging

1
Charge the product fully before first use.
1
Fit the battery (16). Hook the lower end of the
battery into the cleaner, then push the top of
the battery firmly until it locks into place.
The battery will not need to be removed again
unless the product reaches the end of its useful life.
Removal of battery or replacement:
If the battery needs to be removed again, slide the
battery release button
vacuum cleaner handle
of the battery to remove.
Only use battery number 734000-B for this product.
In extreme conditions, batteries may be subject to
leakage. If touched, wash skin with hot soapy
warning. Do not try to use or recharge the battery in
this condition.
2 A
Assemble the charging cradle
cradle base (31). If necessary, the two parts can be
separated again by pressing the charging cradle
base detach button (33), then pulling apart. Insert
the mains adaptor connector
cradle charging inlet (32). Seat the vacuum cleaner
into the charging cradle, ensuring the charging
cradle electrical connectors
handheld vacuum cleaner electrical connectors.
Connect the mains adaptor
4
Floor Floor
vacuum
cleaning in
handstick
mode
2 A
(17) towards the handheld
(6) and pull from the top end
(29) to the charging
(23) into the charging
(28) align with the
(24) to the mains supply.
Handheld
vacuum
cleaning
2 B 3
2 B
Alternatively (provided the unit is in the charging
cradle (29)), insert the mains adaptor connector
into the handheld vacuum cleaner charging inlet (5).
The connector will only fit one way. Connect the
mains adaptor (24) to the mains supply.
After the adaptor is connected, the charge indicator
(8) will illuminate within a few seconds.
3
When the battery is empty and the product is put
onto charge, the first bar of the charge indicator will
start to flash. As the battery charges, the
illumination of this bar will become steady and the
next bar will start to flash. When the illumination of
all 3 bars is steady, the battery is fully charged. This
3 bar steady illumination will remain for 5 minutes,
then the charging process will automatically stop
and the bar illumination will extinguish to save
power. A full charge may take 4 hours.
If all three bars are flashing, this indicates a fault,
please see 'Maintenance - troubleshooting', pages
10 and 11.
When fully charged, the mains adaptor may be
switched off and unplugged. If unused, the batteries
will remain charged for many weeks so there is no
need to keep constantly on charge.
Extended
reach
cleaning in
handstick
mode
(23)