Table of Contents
Advertisement
VC732000MUK Rev3.qxp_Instruction Book 23/02/2015 16:57 Page 6
Charging
Using in upright mode
Turn the product On by pressing the upright
On/Off button (5).
When the product is turned on, the handheld
vacuum cleaner power indicator light
the floor brush power indicator light
illuminate green.
NOTE: When the battery reduces to a pre-set
level the product will stop, the light will
extinguish and the product must be recharged.
On certain models, two power settings are
provided. Press the upright On/Off button
once to switch the product On at high power,
press the button a second time to switch to low
power, then a third press switches the product
Off again (see diagram 2, above right).
6
Connect the mains plug
Locate the vacuum cleaner on to the charging
cradle (15). The indicator light
whilst charging and turn green when fully charged.
A full charge may take 5 hours.
When fully charged, the battery will stay charged
for many days, however, we recommend leaving
the cleaner continuously on trickle charge so the
batteries are always full.
1
Using the product on low power will be sufficient
for light cleaning and will extend the running time
until the product needs to be recharged.
(11)
and
You can also turn the product On with the
(18)
will
handheld vacuum cleaner On/Off button (10). On
the single-power model, switching the power on
using this button will run the rotating brush bar in
the motorised floor brush (19). On the two-power
model, switching the power on using this button
will not run the rotating brush bar in the
motorised floor brush (19).
(5)
NOTE: For both the single-power and two-power
models, there is no variable power settings on
the handheld vacuum cleaner (12).
If the motorised floor brush
3
eg. by a foreign object or if used on very deep
pile carpet, the floor brush power indicator light
(18)
will extinguish. Switch off, remove the
cause of the stall, and leave for a few minutes
to allow the floor nozzle protection to self reset.
To clean the motorised floor brush, you must
remove the handheld vacuum cleaner as shown
in 'Handheld vacuum cleaning', page 7. Then,
press the floor brush release button
pull the motorised floor brush away.
(21)
into the mains supply.
(11)
will glow red
2
(19)
is stalled,
(17)
and
Hide quick links:
Advertisement
Table of Contents
