Set Up And Charging - Morphy Richards Supervac deluxe Instructions For Future Use

VC734055MUK Rev 2.qxp_Instruction Book 08/03/2017 11:41 Page 4
Multiple functionality
vacuum
cleaning
in upright
mode
Your vacuum cleaner can easily be configured into several different cleaning modes:
• Two configurations as a vacuum cleaner for floors and carpets.
• Handheld vacuum cleaner which can be carried with you whilst cleaning.
• Extended reach vacuum cleaner for cleaning hard to reach places such as high coving etc.

Set up and charging

1
Fit the battery (14). Hook the lower end of the
battery into the cleaner, then push the top of
the battery firmly until it locks into place.
The battery will not need to be removed again
unless the product reaches the end of its useful
life.
Removal of battery or replacement:
If the battery needs to be removed again, slide
the battery release button
handheld vacuum cleaner handle
from the top end of the battery to remove.
Only use battery number 734005-B for this
product.
In extreme conditions, batteries may be subject
to leakage. If touched, wash skin with hot
soapy warning. Do not try to use or recharge
the battery in this condition.
2
Insert the mains adaptor connector
handheld vacuum cleaner charging inlet (3).
The connector will only fit one way. Connect
the mains adaptor
4
Floor Floor
vacuum
cleaning in
handstick
mode
2
(15) towards the
(4) and pull
(21) into the
(22) to the mains supply.
Handheld
vacuum
cleaning
3
After the adaptor is connected, the charge
indicator (6) will illuminate within a few
seconds.
3
When the battery is empty and the product is
put onto charge, one bar of the charge indicator
(6) will illuminate. As the battery charges, the
second bar of the charge indicator will start to
flash and then become steady, then the third
bar will start to flash. When the illumination of
all three bars is steady, the product is fully
charged. A full charge may take 6 hours.
The three bars will stay illuminated for 5
minutes and then extinguish to save power.
If all three bars are flashing, this indicates a
fault, please see 'Maintenance -
troubleshooting', page 11.
When fully charged, the mains adaptor may be
switched off and unplugged. If unused, the
batteries will remain charged for many weeks
so there is no need to keep constantly on
charge.
Extended
reach
cleaning in
handstick
mode