Getting Started - Remington HC340 Manual

PARTS
1. On/off switch
2. Blade set
3. 18mm attachment guide comb
4. Charging indicator light
Not shown:
• 6-15mm attachment guide comb
• Blade release buttons
• Scissors

GETTING STARTED

CHARGING YOUR HAIRCLIPPER
• Before using your hair clipper for the first time, charge for 14-16 hours.
• Ensure the product is switched off.
• Connect the charging adaptor to the product and then to the mains.
• The charging indicator will illuminate. The indicator will remain illuminated when
the clipper is fully charged.
• Your hair clipper cannot be overcharged. However, if the product is not going to be
used for an extended period of time (2-3 months), unplug it from the mains and
store. Fully recharge your hair clipper when you would like to use it again.
• To preserve the life of your batteries, let them run out every 6 months then recharge
for 14-16 hours.
INSTRUCTIONS FOR USE
BEFORE STARTING THE CUT
• Inspect the clipper making sure it is free from hair and dirt.
• Seat the person so that their head is approximately at your eye level.
• Before cutting, always comb the hair so it is tangle free and dry.
TO ATTACH A COMB
• Hold the clipper vertically.
• Line the comb rails up with the vertical channels on the sides of the clipper and
slide the comb all the way until it stops.
• NOTE: Please make sure that the comb locking mechanism is not activated (the
switch on the back of the clipper should be in the down position when attaching a
comb).
• Comb
• Storage case
• Cleaning brush
• Oil bottle
• Adaptor
• Comb lock switch (located on back of
clipper)
5