Statuses And Measures - Panasonic SC-HG1-ETC User Manual

4.7.2 Statuses and Measures

The statuses judged by the self-monitoring function are classified into the following four categories.
When the status is "notification", "caution", or "fault", you must check the installation state or
maintain or replace the product.
Status
Normal Normal state
Notification Unstable detection state
Caution State in which the device must be replaced
Fault State in which the device is uncontrollable
If "notification", "caution", or "fault" status is notified, take measures as shown in the following table.
● HG-SC series
For details on Response Parameter adress, refer to "4.4.1 HG-S Series Command List".
Response parameter
Sensor head unconnected
Connected unit count check error
NPN / PNP output type mixture error Status check
Calculated unlit count error
Notifi-
cation
Copy executionerror
( Slave unit problem)
The thrust on the sensor head stroke
is above the specified range.
Pressure check
Catch check
Controller memory function damaged Controller replacement E600 / E610 / E620
Sensor Head memory function damaged Sensor head replacement E630
Output section short-circuit error
Fault
Detection circuit damaged
System error
Note: Error codes and alarms are displayed on HG-SC□ controllers.
WUME-SCHG1ETC-2
Description
Measures
Status check
Status check
Status check
Status check
Status check
Status check
Status check
Status check /
Replacement
Sensor head replacement E240
Controller replacement
4.7 Self-monitoring Function
Remarks
The device is operating normally.
Review the settings.
The device has almost reached its service life.
The device is short-circuited or broken.
Error code (Note)
E200
E160
(For master units only)
E100
(For master units only)
E110
(For master units only)
E170
(For master units only)
E210
–
–
E700
E900 / E910 / E911 /
E912 / E920
Alarm (Note)
–
–
–
–
–
–
Alarm
Alarm
–
–
–
–
–
4-47