Table of Contents
Advertisement
Product Overview
Specifications
Tractors
Height of Cut
Height Of Cut Range
Reel Bearings
Rollers
Bedknife
Bedknife Adjustment
Grass Shield
Counterweight
Net Weight
Attachments/Accessories
A selection of Toro approved attachments and
accessories are available for use with the machine to
enhance and expand its capabilities. Contact your
Authorized Service Dealer or Distributor or go to
www.Toro.com for a list of all approved attachments
and accessories.
These cutting units will mount on the Greensmaster 3300 and 3400 Traction Units.
Cutting height is adjusted on the front roller by two vertical screws and held by two locking
cap screws
Standard bench height of cut range is .062 inch (1.6 mm) to .500 inch (12.7 mm). Bench
height of cut range with the High Height of Cut Kit installed is .285 inch (7 mm) to 1.00 inch
(25 mm). Effective HOC may vary depending on turf conditions, type of bedknife, rollers
and attachments installed.
Two sealed stainless steel, deep groove ball bearings.
The rear roller is a 2 inch (5.1 cm) diameter steel full roller.
Replaceable single edged, high carbon steel bedknife is fastened to a machined cast iron
bedbar with 13 screws.
Dual screw adjustment to the reel; detents corresponding to .0007 inch (.018 mm) bedknife
movement for each indexed position.
Non-adjustable shield with adjustable cut-off bar to improve grass discharge from reel in
wet conditions.
A cast iron weight mounted opposite to the drive motor balances the cutting unit.
8 Blade – 71 lb. (32 kg), 11 Blade – 74 lb. (34 kg), 14 Blade – 77 lb. (35 kg)
9
Advertisement
Table of Contents
