Setup
Media and Additional Parts
Description
Operator's Manual
Parts catalog
Certification of compliance
1
Installing the Front Roller
No Parts Required
Procedure
The cutting unit is shipped without a front roller. Install
the roller using the loose parts supplied with the cutting
unit and installation instructions included with the roller.
2
Using the Cutting Unit Prop
No Parts Required
Procedure
Whenever the cutting unit has to be tipped to expose
the bedknife/reel, prop up the rear of the cutting unit
to make sure the nuts on the back end of the bedbar
adjusting screws are not resting on the work surface
(Figure 3).
Qty.
1
Read before installing and operating cutting unit
1
Use to reference part numbers
1
Save for future reference
g014596
1. Prop (not provided)
3
Adjusting the Bedknife to the
Reel
No Parts Required
Procedure
The bedknife to reel adjustment is accomplished by
loosening or tightening the bedbar adjusting screws,
located on top of the mower.
1. Position the machine on a flat, level work surface.
Make sure the reel contact is removed by turning the
bedbar adjusting screws counterclockwise (Figure 4).
4
Use
2
2
1
Figure 3
2. Bedknife adjusting screw
nut (2)