Table Of Contents; Introduction - Toro Greensmaster 3300 Series Operator's Manual

Introduction

Read this information carefully to learn how to operate
and maintain your product properly and to avoid injury
and product damage. You are responsible for operating
the product properly and safely.
You may contact Toro directly at www.Toro.com for
product and accessory information, help finding a
dealer, or to register your product.
Whenever you need service, genuine Toro parts, or
additional information, contact an Authorized Service
Dealer or Toro Customer Service and have the model
and serial numbers of your product ready. Figure 1
identifies the location of the model and serial numbers
on the product. Write the numbers in the space
provided.
1. Location of the model and serial numbers
Model No.
Serial No.
This manual identifies potential hazards and has
safety messages identified by the safety alert symbol
(Figure 2), which signals a hazard that may cause serious
injury or death if you do not follow the recommended
precautions.
© 2011-The Toro® Company
8111 Lyndale Avenue South
Bloomington, MN 55420
Figure 1
1. Safety alert symbol
This manual uses 2 other words to highlight information.
Important calls attention to special mechanical
information and Note emphasizes general information
worthy of special attention.
Contents
Introduction................................................................. 2
Safety ........................................................................... 3
Safety and Instructional Decals ............................. 3
Setup............................................................................ 4
1 Installing the Front Roller .................................. 4
2 Using the Cutting Unit Prop............................... 4
3 Adjusting the Bedknife to the Reel...................... 4
4 Adjusting the Rear Roller ................................... 5
5 Adjusting the Height of Cut ............................... 6
6 Adjusting the Cut-Off Bar.................................. 7
Product Overview ........................................................ 9
Specifications ....................................................... 9
Attachments/Accessories..................................... 9
Operation................................................................... 10
Cutting Unit Characteristics................................ 10
Daily Adjustments of Cutting Unit ...................... 10
Maintenance............................................................... 11
Servicing the Bedbar........................................... 11
Backlapping the Reel .......................................... 12
2
Figure 2
Contact us at www.Toro.com.
Printed in the USA.
All Rights Reserved