Mounting - Bosch D296 Installation Manual

Long-range beam smoke detectors
4

Mounting

Notice!
Use this product in indoor, dry applications only.
1.
2.
Figure 4.1: Access Door and Cover
3.
Figure 4.2: Removing the Back Plate
Warning!
Remove power to all wiring before proceeding.
!
4.
Bosch Security Systems, Inc.
Install a 4‑in. square or octagonal electrical box (or equivalent) to a rigid surface. Ensure
that the surface is not subject to movement or vibrations.
Remove the screw on the receiver's access door. Then remove the cover's four screws
indicated in the following figure.
1 Access door
Unscrew the single mounting screw at the top of the circuit board carrier plate and
separate the plates See the following figure.
1 Remove screw to expose back plate
2 Mounting slots (4)
3 Back Plate
Route the wiring from the electrical box through the wire entrance. If you are going to
connect a D344‑RL or D344‑RT to the receiver, route that wiring also.
2 Cover mounting screws (4)
4 Wiring entrance
5 Do not remove
Installation manual
Mounting | en 13
2017.03 | 7.0 | F.01U.068.899