Part Names Of The Memory Card - Mitsubishi Melsec-Q Series User Manual

7.1.3 Part names of the memory card

The part names of the memory card are described below.
1)
No.
1) Connector area
2) Battery holder
Battery holder fixing
3)
switch
4) Write protect switch
*1: The battery holder fixing switch is returned automatically from the RELEASE to LOCK position when the battery holder is
disconnected.
7 - 4
3)
4)
Write protect ON
"LOCK"
"RELEASE"
2)
Figure 7.2 Memory card
Name
Connector area connected to the CPU module
Used to set the lithium battery for data backup of the SRAM memory (SRAM card only)
Switch for fixing the battery holder to the memory card. Locked at: LOCK position (write
protect switch side)
*1
LOCK: Locked, RELEASE: Unlocked
(SRAM card only)
Used to set write prohibit in the memory. Set to off by factory default.
(SRAM card and Flash card only)
On: Data write inhibited
Off: Data write enabled
3)
"LOCK"
2)
"RELEASE"
Table7.6 Part names
Descriptions
1)
Write protect ON
4)