Battery Installation Into The Memory Card - Mitsubishi Melsec-Q Series User Manual

Hide thumbs Also See for Melsec-Q Series:

Table of Contents

7.1.7 Battery Installation into the memory card

Installation method of the battery for the memory card (SRAM card)

The battery for the SRAM card is removed from the battery holder when shipping.

Before installing the SRAM card into the CPU module, set the battery holder as shown in Figure 7.8.

(1) For Q2MEM-1MBS and Q2MEM-2MBS

Set the battery holder's locking switch to

the "RELEASE" position.

Remove the battery holder from the SRAM card.

Set the battery onto the battery holder

with the "plus" face up.

Insert the battery holder with which the

battery is installed firmly, into the SRAM

Confirm that the battery holder's locking

switch is set to the "LOCK" position.

Insert or remove the battery in the horizontal direction along the battery holder fixing guide.

Failure to do so may damage the latches of the battery holder.

Side with "product name"

The battery holder's locking switch is set automatically to the

"LOCK" position when the battery holder is removed. In its position,

insert the battery holder firmly.

Figure 7.8 Memory card battery setting procedure

Battery holder latches

Battery fixing guide

Battery holder

Figure 7.9 Battery setting direction

CHAPTER7 MEMORY CARD AND BATTERY

Battery holder's locking switch

RELEASE position

Battery holder

Show Quick Links

Table of Contents