Scan Set Screen - Icom IC-705 Advanced Manual

8. SCANS

SCAN SET screen

1. Display the SCAN screen.
» SCAN
2. Touch [SET].
3. Touch the item to set.
(Example: SCAN Speed)
4. Touch the option to set. (Example: Slow)
5. To close the SCAN SET screen, push
TIP: You can set each item to its default by
touching the item for 1 second, and then
touching "Default" on the QUICK MENU screen.
SCAN Speed
Sets the desired scan speed to slow or fast.
• Slow: Scan speed is slow.
• Fast: Scan speed is fast.
SCAN Resume
Sets the Scan Resume function to ON or OFF.
• OFF: When a signal is detected, cancels the scan.
• ON: When a signal is detected, the scan
pauses for 10 seconds, then resumes.
Two seconds after the signal disappears,
the scan resumes.
Pause Timer
When Scan Resume is ON, selects the Scan
Pause Timer. When receiving a signal, the scan
pauses for this set period of time.
• 2 ~ 20sec: When a signal is received, the scan
pauses for 2 ~ 20 seconds (in 2
second steps).
• HOLD: The scan pauses on a received
signal until the signal disappears.
.
(Default: Fast)
(Default: ON)
(Default: 10sec)
8-3
Resume Timer
Selects the scan Resume Timer. When a
received signal disappears, the scan resumes
after this set period of time passed.
• 0sec: The scan resumes immediately after
the signal disappears.
• 1 ~ 5sec: The scan resumes 1 ~ 5 seconds
after the signal disappears.
• HOLD: The scan remains paused for the
Pause Timer setting, even if the
signal disappears.
Temporary Skip Timer
Sets the Temporary Skip Timer. The unwanted
frequencies that are set as Skip channels (PSKIP
or SKIP) are skipped for this set period of time
during a scan.
LThis timer is activated for the VFO scan, Memory
scan, and DR scan.
• 5min/10min/15min: Skip channels are skipped
• While Scanning:
• While Powered ON: Skip channels are skipped
MAIN DIAL Operation (SCAN)
Selects the function of
• OFF: Rotating
• Up/Down: Rotating
scanning direction.
Program Scan Edge
You can delete, copy, or edit the lower and higher
frequencies for programmed scans.
The transceiver has a total of up to 25 frequency
ranges (00 ~ 24), and you can set the scan
name, mode, and the IF filter for each Scan
Edge.
LThe default setting may differ, depending on the
transceiver version.
LSee page 8-5 for entering Scan Edges.
(Default: 2sec)
(Default: 5min)
for the set period of time.
Skip channels are skipped
until the scan is stopped.
until the transceiver is
turned OFF.
(Default: Up/Down)
while scanning.
stops the scan.
changes the